Table of Contents
Advertisement
System expansions
Remove the protection shield (4).
Ê
Do not throw away the covers. For cooling, protection against fire and in order to comply
i
with EMC regulations, you must refit the covers if you remove the drive again later.
A
A = Position of screw for non-accessible drive
B = Position of screw for accessible drive
Take the new drive out of its packaging.
Ê
Push the drive into the bracket and secure it with four screws.
Ê
2
Push the bracket into the system unit until it snaps into place (1).
Ê
Plug the connectors of the data cable and the power supply cable into the drives (2). Make sure
Ê
the polarity is correct.
Close the system unit (see "Assembling the system unit").
Ê
i
If necessary, you must adapt the entry for the drive in the Setup menu.
38
B
A
B
Installing and removing drives
1
A26361-K622-Z100-1-7619
Advertisement
Table of Contents
