Fujitsu Siemens Computers SCENIC eD Operating Manual page 42

System expansions
Fasten the guide rails with the four screws on the drive.
Ê
Make the required settings on the drive (if necessary, on installed drives as well).
Ê
If the drive is the first 5 1/4" drive in your system, then use the upper bay, and use the lower
Ê
bay for the second 5 1/4" drive.
Insert the drive in the bay so that the guide rails on the drive fit into the guides in the drive
Ê
cage. Slide the drive into its bay until it snaps in place (1).
Plug the connectors of the data cable and the power supply cable into the drive (2). Make sure
Ê
the polarity is correct.
Close the system unit (see "Assembling the system unit").
Ê
i
If necessary, you must adapt the entry for the drive in the Setup menu.
34
Installing and removing drives
1
2
A26361-K622-Z100-1-7619