Table of Contents
Advertisement
Chapter 7: Admin Control Panel
7.7 E-mail
Figure 7-10. E-mail screen.
Use this page to set e-mail parameters and recipients' addresses.
You must set the SMTP server. See the Configuration/SMTP setting.
The sender Name and E-mail are the addresses of your ControlBridge Unit. The sender Name and E-mail are used by the XPL2
commands EmailSend and PresetEmailSend.
The recipient Names and E-mails are addresses of recipients where e-mails will be sent using the XPL2 command
PresetEmailSend.
7.8 System
Firmware
Figure 7-11. Firmware screen.
Use this page to update the ControlBridge Unit firmware. The Current version of firmware is shown. To upload new firmware,
select the desired version, and click the Upload button.
877-877-2269 | blackbox.com
Page 45
Advertisement
Table of Contents
