Table of Contents
Advertisement
Chapter 3: Installation
3.2 Rackmounting
The Rackmounting Shelf (CB-CP-RMK) provides a simple solution for installing controllers in a 19-inch rack. It allows you to
install up to two half-rack sized controllers in a single 19-inch unit rack space. All necessary accessories are supplied with the
shelf.
Attach the controller to the Rackmounting Shelf using two M3 x 6 screws to the female threads on the bottom side of the
controller - see picture below. The M3 x 6 screws are included with the Rackmounting Shelf. Don't use longer screws; this
might damage PCBs inside the unit. If you install only one controller, use the cover panel delivered with the shelf.
NOTE: If you install less controllers, use the cover panels delivered with the shelf to cover empty positions.
Page 14
IR SENSOR
SERIAL
IR/SERIAL
GENERAL I/O
RELAY
12
123
4
123
41
2
Screws M3 x 6
Cover panel 1/4
Figure 3-2. Rackmounting the ControlBridge Processor(s).
877-877-2269 | blackbox.com
Screw holes
IR SENSOR
SERIAL
IR/SERIALG
12
123
4
1234
Screws M3 x 6
Cover panel 1/2
ENERAL I/O
RELAY
12
Advertisement
Table of Contents
