Capturing Ir Codes - Black Box ControlBridge CB-PS-12V User Manual

Chapter 4: Operation

4.3.1 Capturing IR Codes

All controllers are equipped with an IR capture sensor and are able to capture IR codes. Captured IR codes can be used in both
controller models.
The capture procedure consists of the following steps:
1. Connect the capture unit and the PC with ControlBridge Builder to the same Network.
2. Arrange the IR remote and the capture unit as described below.
• Be sure to set the proper distance between the capturing unit and the remote unit to accommdate the the capturing unit's
requirements.
• Start ControlBridge Builder and go to the appropriate driver and command
• Set the IP address of the unit used for capture.
• Push the Start Capture button in ControlBridge Builder and then press the appropriate button on the IR remote.
Page 18
IR SENSOR SERIAL IR/SERIAL GENERAL I/O
1 2 1 2 3 4 1 2 3
IR remoter
Figure 4-1. IR remote configuration.
Figure 4-2. Start Capture button.
877-877-2269 | blackbox.com
RELAY
4 1 2
Button Start Capture