Operating Instructions - Intex L ZS6220 Owner's Manual

Krystal clear ozone & saltwater system
Table of Contents

Advertisement

(328IO) MODEL ZS6220 & ZS6230 OZONE & SALTWATER SYSTEM ENGLISH 7.5" X 10.3" PANTONE 295U 07/14/2017
OPERATION INSTRUCTIONS
IMPORTANT: To maximize the ozone output of the system, select a daily start time, usually
after 10:00am, when humidity is the lowest.
1. Turn on the filter pump.
2. Start up the unit:
Plug the power cord into the electrical outlet and test the GFCI/RCD
(circuit breaker). Press
electronic control station's LED, indicating that the unit is ready to be
programmed.
3. Set operating hours for Ozone & Saltwater system:
With code "00" flashing, press
desired operating hours. See the "Operating Time
Table" for the required operating hours related to
each pool size. Pressing
from 01 to 12 hours maximum. If you have selected
too many hours keep pressing
cycle. The built-in timer will now activate your
Ozone & Saltwater System, at the same time each day,
for the number of hours you have set.
NOTE: The Ozone & Saltwater System will not operate if the filter pump is not operating.
Make sure to program your filter pump (or start it manually) for operation beginning 5 minutes
before the Ozone & Saltwater System and finishing 15 minutes after the Ozone & Saltwater
System.
4. Lock keypad controls:
With the desired hour value showing, press
hear a "beep". A green "WORKING" indicator on the control panel
will light up within a few seconds to indicate that the Ozone &
Saltwater system has started chlorine-ozone production. Locking
the control buttons into this setting prevents unauthorized changing
of the operating cycle.
NOTE: If you forget to lock the keypad controls, the system will
automatically lock it and start working 1 minute later.
5. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary.
Press
button until you hear a "beep" to unlock the
keypad and the current programmed time will flash.
Repeat steps 3 to 4.
SAVE THESE INSTRUCTIONS
button. Flashing code "00" appears on the
button to set the
will increase the time
to repeat the
button until you
English
(1 to 12 hours max per cycle)
Page 13
328A

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zs6230

Table of Contents