Operating Instructions - Intex Auto Cleaner Owner's Manual

SETUP INSTRUCTIONS (continued)
6. With hose clamp (6), fasten the
end of hose D (11) to the top
connection of cleaner. A small
coin can be used to tighten the
hose clamp. See Fig. 6.
7. Place auto cleaner into the water.
Fill up the hose assembly with
water by submerging the hose
into the water to remove all of the
entrapped air from the hose.
8. Connect hose B (9) from the hose assembly to the hose A (8) which
was already installed in step 4. See Fig. 7.
IMPORTANT: Run the filter pump for 10-15 minutes before connecting
the auto cleaner to the water return connector.
9
9. Set up the Filter Pump following the Filter Pump owner's manual. The
auto cleaner is now ready to use.

OPERATING INSTRUCTIONS

1. The filter pump is an airtight system. In a counter-clockwise motion turn
the top air release valve 1 – 2 turns to open it.
2. When water starts flowing out of the air release valve hole, screw in the
air release valve back into the filter housing cover. Do not over tighten
the valve.
3.
Connect the filter pump to the power
outlet and turn ON the pump.
4. Hold the auto cleaner upside down
below the water surface to jet out
the water. See Fig. 8. This will
evacuate all the air in the hose
and auto cleaner, so the cleaner
will sink to the bottom and keep
the pool clean.
S AVE THESE INSTRUCTIONS
(198IO) AUTO CLEANER ENGLISH SIZE: 4.875" X 7.25" PANTONE 295U 08/16/2013
8
English
11
6
198A
6
7
8
Page 6