Setup Instructions - Intex L ZS6220 Owner's Manual

(328IO) MODEL ZS6220 & ZS6230 OZONE & SALTWATER SYSTEM ENGLISH 7.5" X 10.3" PANTONE 295U 07/14/2017
• The Ozone & Saltwater System requires a separate filter pump [1500~4000 gph
(5680~15140 lph)] to drive the water and function properly.
• The Ozone & Saltwater System must be installed as the last piece of pool equipment in
the water return line to the pool as displayed in Drawing #1. This location extends the
life of the titanium plates.
1. Assemble the above-ground-pool (AGP) and its filter pump according to their installation
instructions.
2. Take the Ozone & Saltwater System and its accessories out of the packaging.
3. Place the Ozone & Saltwater System in line after the filter pump.
4. Connect the connector hose (8) to the Ozone & Saltwater System inlet.
Connecting the system to pump and pool with 1-1/2" (38mm) connections/hoses,
install as follows:
Drawing #1
WATER TO
POOL
ID 1-1/2" (38mm)
HOSE
1. Go directly to step 2 if your pool is empty. If your above-ground-pool is filled with water,
close the plunger valves before installing the Ozone & Saltwater System.
2. Disconnect the water return hose from the filter pump connection and connect it to the Ozone
& Saltwater System outlet.
3. Connect the connector hose (8) to the filter pump outlet connection.
4. Open the plunger valves to allow the water to flow.
SAVE THESE INSTRUCTIONS

SETUP INSTRUCTIONS

IMPORTANT
SWIMMING POOL
8
OZONE &
SALTWATER
SYSTEM
FROM POOL
FILTER
PUMP
ID 1-1/2" (38mm)
HOSE
English
328A
PLUNGER
VALVE
WATER
Page 6