Setup Instructions - Intex ZX300 Quick Start Manual

(178PO) ZX300 DELUXE AUTOMATIC POOL CLEANER ENGLISH SIZE: 4.875" X 7.25" PANTONE 295U 08/21/2020
IMPORTANT PREPARATION INFORMATION
please read, understand, and follow all instructions carefully before
installing and using this product.
General
• The Auto cleaner operates from the pressure side of the pool water
return connector (water from the filter pump to the pool).
• if an intex saltwater system or ozone Generator is attached to the
pool, disconnect these sanitation devices from the circulation line
first before operating the Auto cleaner. once the Auto cleaner
has finished cleaning the pool, disconnect, remove the Auto
cleaner from the pool and resume the sanitation device operation.
• The Auto cleaner must be connected to a filter pump with a pump
flow rate between 1600 - 3500 gallons/hour (6056 - 13248 liters/
hour).
• for intex above ground frame pools with 1-1/2" (38 mm) threaded
®
strainer connector hose fitting (not suitable for Easy set pools or
pools with inflatable top ring).
• Up to 26 ft (7.92 m) round shape.
• Up to 32 ft x 16 ft (9.75 m x 4.88 m) rectangular/oval shape.
• first assemble your pool and filter pump, and then set up the auto
cleaner.
• if using a sand filter, ensure the sand media is clean by
backwashing it first. Run the filter pump for 10-15 minutes before
connecting the auto cleaner to the water return connector.
• The auto cleaner will not work if the filter pump is not operating.
S AVE THESE INSTRUCTIONS

SETUP INSTRUCTIONS

Page 5
178
PO