Setup Instructions - Intex ZX100 Owner's Manual

IMPORTANT PREPARATION INFORMATION
Please read, understand, and follow all instructions carefully before installing and
using this product.
General
The auto cleaner is designed to clean the pool as follow:
• The brushes from the auto cleaner remove the fine dirt from the floor.
• The fine sediments and debris on the floor are agitated by the auto cleaner
movement. This allows the filtration system to filter out the fine sediments
suspended in the water, while the auto cleaner pick up the heavy debris
on the floor.
• The movement of the auto cleaner around the pool prevents the water from
stagnating. Thus helping circulate the pool water through the filtration system.
• The Auto Cleaner operates from the pressure side of the pool water return
connector (water flowing from the filter pump to the pool). If the Auto Cleaner
is attached to the pool "outlet" (water flowing from the pool to the filter pump)
connector, it will not work.
• The Auto Cleaner will not work if there is an Intex Saltwater System or Ozone
Generator connected to the same water circulation line as the Auto Cleaner.
Disconnect these sanitation devices from the water circulation line before
installing the Auto Cleaner. Once the Auto Cleaner has finished cleaning the
pool, disconnect, remove the Auto Cleaner from the pool, reinstall and resume
the sanitation device operation.
S AVE THESE INSTRUCTIONS
(77IO) ZX100 AUTOMATIC POOL CLEANER ENGLISH SIZE: 4.875" X 7.25" PANTONE 295U 06/22/2022

SETUP INSTRUCTIONS

Dirt in the pool
Page 5
77
A