Advertisement
SETUP INSTRUCTIONS (continued)
9.
Connect hose B (9) from the hose assembly to the hose A (8) which
was already installed in step 4. See Fig. 8.
IMPORTANT: Run the filter pump for 10-15 minutes before connecting
the auto cleaner to the water return connector.
9
10. Set up the Filter Pump following the Filter Pump owner's manual. The
auto cleaner is now ready to use.
OPERATING INSTRUCTIONS
1.
The filter pump is an airtight system. In a counter-clockwise motion turn
the top air release valve 1 – 2 turns to open it.
2.
When water starts flowing out of the air release valve hole, screw in the
air release valve back into the filter housing cover. Do not over tighten
the valve.
3.
Connect the filter pump to the power outlet and turn ON the pump.
4.
Hold the auto cleaner upside down below the water surface to jet out
the water. See Fig. 9. This will evacuate all the air in the hose and
auto cleaner, so the cleaner will sink to the bottom and keep the pool
clean.
S AVE THESE INSTRUCTIONS
(100PO) AUTO CLEANER ENGLISH SIZE: 4.875" X 7.25" PANTONE 295U 07/26/2012
8
100
English
PO
8
9
Page 7
Advertisement
