Setup Instructions - Intex ZX50 Owner's Manual

IMPORTANT PREPARATION INFORMATION
please read, understand, and follow all instructions carefully before installing and
using this product.
General
• The Auto cleaner operates from the suction side of the pool water outlet
connector (water flowing from the pool to the filter pump).
• if an intex saltwater system or ozone Generator is attached to the pool,
disconnect these sanitation devices from the circulation line first before
operating the Auto cleaner. once the Auto cleaner has finished cleaning
the pool, disconnect, remove the Auto cleaner from the pool and resume the
sanitation device operation.
• The Auto cleaner must be connected to a filter pump with a flow rate between
900 - 1500 gallons/hour (3407 - 5678 liters/hour).
• for intex ® above ground frame pools with 1-1/2" (38 mm) and 1-1/4" (32 mm)
threaded strainer connector hose fitting.
• Up to 16 ft (4.9 m) round shape.
• Up to 20 ft x 10 ft (6.1 m x 3.05 m) rectangular/oval shape.
• for 18 ft (5.49 m) and 20 ft (6.1 m) round pools, a separate extension
hose (12) is required. contact your nearest local service centers to
purchase this part.
• first assemble your filter pump and then set up the auto cleaner.
• The auto cleaner will not work if the filter pump is not operating.
• The auto cleaner is designed to clean the pool as follow:
• The brushes from the auto cleaner remove the fine dirt from the floor.
• The fine sediments and debris on the floor are agitated by the auto
cleaner movement. This allows the filtration system to filter out the fine
sediments suspended in the water, while the auto cleaner pick up the
heavy debris on the floor.
• The movement of the auto cleaner around the pool prevents the water
from stagnating. Thus helping circulate the pool water through the
filtration system.
S AVE THESE INSTRUCTIONS
(78IO) ZX50 MINI AUTOMATIC POOL CLEANER ENGLISH SIZE: 4.875" X 7.25" PANTONE 295U 08/21/2021

SETUP INSTRUCTIONS

Page 5
78A