Download Print this page

Craftsman 113.177035 Owner's Manual page 12

16 gallon cord retractor wet/dry vac
Hide thumbs

Advertisement

Wet Nozzle
To pick up liquids off a smooth
surface,
use the 2-1/2" wet nozzle accessory
sup-
plied with your wet/dry vac. To use this
nozzle, simply attach the nozzle to the
end of an extension
wand.
Connect
a second extension
wand to the
first, and connect the 2-1/2" x 7' hose to
the extension
wand.
Liquids
may be picked up by dragging the
nozzle across the surface. The squeegee
will dry the surface as you vacuum.
Replacement
rubber for the squeegee
nozzle may be obtained
through
Sears
Parts. If the rubber becomes
worn, it may
be flipped over for use on the opposite
side or replaced.
(Replacement
service
part #822256).
To reverse or replace the
squeegee:
1. Lay the wet nozzle on a flat surface with
the round inlet opening facing up and
the two latches close to you as shown.
Latches
Nozzle
3ody
Removable
Insert
2. Using both hands, position each thumb
on the removable
insert, (below the
latches) and two fingers of each hand
on each latch, lift and disengage
the
two latches from the tabs on the nozzle
body.
3. Gently pull the latches toward yourself
to remove the insert.
To reinstall the removable
insert correctly,
follow these steps:
1. Place the removable
insert on a flat sur-
face with the pins positioned
upward
and the latches close to you as shown.
Place the rubber squeegee
on the
insert, with the pins fitting through the
matching
holes in the squeegee.
(Make
sure the new working edge is located
farthest from you.)
[
2. Using both hands, lower the nozzle
body onto the insert and squeegee
with
the round opening
of the nozzle closest
to you. With fingers on the far side and
thumbs
holding the latches of the
removable
insert, flip the nozzle over so
the latches are on the top and the round
inlet opening
is facing away from you.
Make sure the squeegee
stays on the
insert pins.
3. Press
down with each
thumb
below the
latching
tabs until you see and hear the
removable
insert snap
into the nozzle
body. Snap
the latches
ever the locking
tabs into their original position.
4. Inspect the pins of the insert to make
sure they fit through
the holes of the
squeegee
and fit into the matching
slots
in the nozzle body.
NOTE: If the pins are out of position,
hold the nozzle assembly
with both
hands and gently twist in opposite
directions.
The insert pins should snap
into proper position.
Twist
Twist
Backward
Forward
The wet nozzle
assembly
is ready
for wet
pickup use.
12

Advertisement

loading

  Related Manuals for Craftsman Craftsman 113.177035