3.Whentheliquidin thedrumreaches a
predetermined l evel, t hefloatmechanism
willriseautomatically t o cutoffair-flow.
motornoisewillbecome higherin pitch,
dueto increased motorspeed. W henthis
happens, t urnoffthe vac,unplugthe
• 4.Afterusingthe vacto pickup liquids,
thefilter mustbedriedto avoidpossible
mildewand damageto the filter.
IMPORTANT: Toavoiddamage tothe vac
do not run motor with float in raised position.
the risk of fire
Do not run vac
ARNING: To reduce the risk of injury
from accidental starting, unplug power
cord before emptying the drum.
1. The vac comes
with a drain
for easy emptying
of liquids. Simply
unscrew the drain cap and lift the oppo-
site side slightly to empty the drum.
option is to remove the power
Pull the flexible latches out-
ward on each side of the lid to release
from the drum.
3. While holding the latches out, lift the
up and away from the
4. Lay power assembly
upside down on a
clean area while emptying
5. Dump the drum contents
into the proper
waste disposal container.
the risk of
back injury or fa!ls, do not lift a vac
heavy with liquid or debris. Scoop
or drain enough
make the vac light enough to lift
Moving the Vac
1. Should it become necessary
to pick the
vac up to move it, DO NOT pick the vac
up by the lid handles
unless dust drum
is empty. To avoid dropping the vac due
or possible part
pick the vac up by the lip of
the dust drum.
Your vac features
blow sawdust and other debris. Follow the
steps below to use your vac as a blower.
Always wear safety gog-
with ANSI Z87.1
before using as a blower.
To reduce the risk of
injury to bystanders,
clear of blowing
1. Locate blowing
port of your vac.
2. Insert the male/male
adapter into the
locking tab adapter end of the hose.
Insert the opposite end of the male/male
adapter into the blowing port of the vac.
swivel end of hose, then place a blower
nozzle on the wand.
4. Turn vac on and you are ready to use
your vac as a blower.
at Sears retail stores. The Sears
Blower Nozzle Stock No. 9-16933 and
Stock No. 9-16964
for blowing debris.