For your own safety,
plug to power source
outlet until all assembly
and you have read and
the safety and operation
Do not operate
with any parts damaged
1. Place the power assembly
upside down into the drum.
2. Locate the float. Place the float over the
in the center of the lid with the
words "This Side Towards Lid" laying
face down over the hole.
To reduce the risk of per-
sonal injury or damage
to vac be
sure to keep hands,
out of the cen-
3. Line up filter cage tabs wittl the slots in
the center ring of the lid.
4. Push on the filter cage until the tabs
snap into the slots for a secure fit.
slide the filter over the filter
cage, sliding it over the center ring cov-
ering the 3 slots until the filter stops
against the lid.
2. Place the hole in the filter plate over
screw of the filter cage.
3. Gently push on the filter plate to seat
the rubber ring of the filter inside the cir-
of the filter plate.
4. Place filter nut onto threaded
tighten it down. Finger tighten only.
Lever of filter nut should be away
from plate as shown.
DO not overtighten
may deform or crack the filter plate or filter
NOTE: Your filter has a red stripe that
an in-store displayer.
visit your local Sears store, just remember the
color of your stripe fer the correct size filter.
NOTE: If filter cage needs to be removed,
because the float is placed in the wrong
way, use a flat bladed screwdriver
insert the blade near one of the tabs
between the filter cage and the center ring
of the lid. Pry the tab out of the slot. Tilt the
cage and lift away from the lid. To replace,