To Sew - Kenmore 385.12102 Owner's Manual

Zipper Sewing (Continued)
• TO sew
(D Zipper teeth
(_) Zipper tape
® Wrong side (Bottom side) of fabric
[] Fold back the left seam allowance. Turn under the right
seam allowance to form a 1/8" (0.2 to 0°3 cm) fold.
Place the zipper teethO next to this fold and pin in place..
[] To sew the left side of the zipper, set the zipper foot on
the left side of the needle. Lower the zipper foot on the
top side at the bottom of the zipper so that the needle
pierces the fabric next to the fold and the zipper tape ®.
Sew through all layers next to the fold. Stop just before
the zipper foot reaches the slider on the zipper tape
about 2" (5 cm) from the top of the zipper.. Lower the
needle slightly into the fabric, raise the fool
Q Slider
[] Open the zipper to move the sliderQ behind
the zipper foot,
Lower the foot and stitch the remainder of the
seam, making sure the fold is even°
(_) Right side (Top side) of fabric
[] Close the zipper and spread the fabric flat with
the right side (top side) of fabric®facing Upo
[] Set the zipper foot on the right side of the needle,.
Guide the edge of the foot along the zipper teethO
and stitch through the garment and zipper
tape.
[] Stop at about 2" (5 cm) from the top of the zipper° Lower
the needle slightly into the fabric, raise the foot and
remove the basting stitches along zipper opening.
Open the zipper to move the slider (_ behind the zipper
foot,.
Lower the foot and stitch the remainder of the seam,
making sure the fold is even°
34
r
[]
r
[]
r
[]
................................... .,J
®
®
[]