Error Messages - Marantz PM-KI RUBY Owner's Manual

ENGLISH
n Desired sound does not come out
Symptom
No sound comes out of a specific
speaker.
The left and right of stereo sound is
reversed.
n Sound is interrupted or noise occurs
Symptom
When playing a record, the sound is
distorted.
When playing a record, a humming
noise comes out of the speakers.
When playing a record, a humming
noise comes out of the speakers when
the volume is high. (Howling
phenomenon)
Audio sources recorded through this unit
are distorted.

Error messages

When multiple PM-KI RUBY units are connected by F.C.B.S., the error messages described in the table below may be displayed on the display. In such a case, ID number setting or remote cable
connection may be in failure. Check the ID number or remote cable connection, referring to the table below. For details on ID number setting, see "How to set ID number for F.C.B.S." (v p. 11).
Indication
ERROR 02 Multiple amplifiers take ID No.2.
ERROR 03 Multiple amplifiers take ID No.3.
ERROR 04 Multiple amplifiers take ID No.4.
ERROR 11 The amplifiers with ID No.2-4 cannot communicate with the amplifier with ID No.1.
ERROR 12 The amplifier with ID No.1 cannot communicate with the amplifiers with ID No.2-4.
25
Check that speaker cables are properly connected.
0
Adjust the left and right channel balance.
0
Check whether the left and right speakers are connected to the correct speaker terminals.
0
Adjust to a proper needle pressure.
0
Check the tip of the needle.
0
Replace the cartridge.
0
Check that the turntable is connected correctly.
0
If there is a TV or AV device near the turntable, such devices may affect the playback sound. Install the turntable in a location as far
0
away as possible from the TV or other AV devices.
Install the turntable and speakers as far from each other as possible.
0
The vibrations from the speakers are being transmitted to the player through the floor. Use cushions, etc., to absorb the speakers'
0
vibrations.
If two recording devices are connected to this unit, turn on the power of both recording devices when recording. If the power of only
0
one recording device is turned on, the recording device that is turned off may cause distortion of the audio recorded to the other
recording device, depending on the type of recording device.
Meaning
Cause / Solution
Cause / Solution
Assign different ID numbers to the amplifiers.
0
If the amplifier with ID No.1 is not on, turn it ON.
0
Check that the remote cable is properly connected.
0
If multiple amplifiers take ID No.1, set ID numbers properly.
0
If the amplifier with ID No.1 is connected to the amplifier with ID No.0, set ID
0
numbers properly.
Check that the remote cable is properly connected.
0
Cause / Solution
Page
8
17
8
Page
－
－
－
9
－
9
－
18