Stereo Complete Bi-Amp Connection - Marantz PM-KI RUBY Owner's Manual

ENGLISH
n How to set ID number for F.C.B.S.
SPEAKERS SPEAKERS IMPEDANCE : 4 IMPEDANCE : 4 16 16
CD CD LINE-1 LINE-1 LINE-2 LINE-2 RECORDER- RECORDER-1 RECORDER- RECORDER-2 RECORDER- RECORDER-1 RECORDER- RECORDER-2
AUDIO IN AUDIO IN AUDIO OUT AUDIO OUT POWER AMP IN POWER AMP IN
SIGNAL SIGNAL PHONO PHONO
GND GND
AUDIO IN AUDIO IN
INPUT
SELECTOR
X
.
11
1
While holding F.C.B.S. ID on the rear panel,
press X.
IN IN OUT OUT STEREO STEREO
BI-AMP BI-AMP
2
REMOTE CONTROL REMOTE CONTROL AMP MODE AMP MODE
Turn INPUT SELECTOR on the unit to select
IN IN OUT OUT ID ID
F .C.B.S. F .C.B.S.
AC IN AC IN
an ID number.
For a master unit, ID number 1 needs to be
0
assigned. For a slave unit, set any of ID numbers 2
to 4.
3
F.C.B.S. ID
Turn the unit off.
4
Again turn the unit on.
The ID number appears on the display for around 3
seconds.
The setting is saved.
0
The unit registered as a slave shows "SLAVE" on the
0
display.
If using this unit by itself as a stereo amplifier, set the ID
0
number to "0". (Default setting is "0".)
If the ID number is set to a number other than "0", this unit
0
cannot be used for standalone operation.

Stereo complete bi-amp connection

This mode enables the two amplifiers connected to this unit
to function as one monaural amplifier. To use this mode, two
F.C.B.S. connected PM-KI RUBY units are required.
To switch the mode, use the AMP MODE switch on the rear
panel while the power is off.
If this unit is set to the bi-amp mode, "BI-AMP" appears on the
display.
In bi-amp mode, connect to the left channel input connector.
The right channel input is disabled.
The same signals are output from the left and right speaker
terminals.
Be sure to turn the power off before operating the AMP
0
MODE switch. Settings can be configured when the power
is turned on.
When in bi-amp mode, the R channel input connectors
0
cannot be used.
When in bi-amp mode, the signals input into the L channel
0
are output from both channels. Therefore, the same signals
are output from the L channel and R channel in
RECORDER OUT, headphones jack.
Speaker systems connected using complete bi-amp
0
connections must support bi-amp connections. Before
connecting your speakers, check in the instruction manual
that came with the speakers or contact the manufacturer to
confirm whether they support bi-amp connection.