Assembly; Remove The Chemical Pump From The Shipping Carton; Add Engine Oil - Champion 100192 Owner's Manual

ASSEMBLY

Your chemical pump requires some assembly. This unit
ships from our factory without oil. It must be properly
serviced with fuel and oil before operation.
If you have any questions regarding the assembly of your
chemical pump, call our help line at 1-877-338-0999.
Please have your serial number and model number
available.

Remove the Chemical Pump from the Shipping Carton

1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the
chemical pump.
3. Carefully cut each corner of the box from top to bottom.

Add Engine Oil

CAUTION
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil. Damage to the
chemical pump as a result of failure to follow these
instructions will void your warranty.
NOTE
The recommended oil type is 10W-30 automotive
oil.
1. Place the chemical pump on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Using a funnel add up to 0.6 qt. (0.6 L) of oil (not
included) and replace oil fill cap/dipstick.
4. It is recommended to only fill to the base of the oil fill
hole. DO NOT OVERFILL.
5. Check engine oil level daily and add as needed.
NOTE
Once oil has been added, a visual check should show
oil about 1-2 threads from running out of the fill hole.
If using the dipstick to check oil level, DO NOT screw
in the dipstick while checking.
7
Add Engine Oil Cont'd.
NOTE
Check oil often during the break-in period. Refer to the
Maintenance section for recommended service intervals.
CAUTION
The engine is equipped with a low oil shut-off and
will stop when the oil level in the crankcase falls
below the threshold level.
NOTE
Weather will affect engine oil and engine
performance. Change the type of engine oil used
based on weather conditions to suit the engine
needs.
Degrees Celsiusº (Outside)
Full Synthetic 5W-30
Degrees Fahrenheitº
NOTE
We consider the first 5 hours of run time to be the
break-in period for the engine. During the break in
period we recommend using standard automotive
non-synthetic blended oils. After the break in
period synthetic lubricant can be used but is not
required. Adjusting throttle setting will increase/
decrease engine speed helping to seat piston
rings. Avoid bogging or lugging the engine down
and avoid prolonged running at constant RPM.
After the 5 hour break-in period, change the oil.
Using synthetic lubricants does not increase the
recommended oil change interval.
NOTE
Synthetic oil may be used after the 5 hour initial
break-in period. Using synthetic oil does not
increase the recommended oil change interval.
100192
ENGLISH
(Outside)