Champion 100192 Owner's Manual page 7

2 inch chemical water transfer pump with clear water fittings
Table of Contents

Advertisement

100192
ENGLISH
DANGER
Fuel and fuel vapors are highly flammable and
extremely explosive.
Fire or explosion can cause severe burns or death.
Unintentional startup can result in entanglement,
traumatic amputation or laceration.
When adding or removing fuel:
Turn the engine off and let it cool for at least two
minutes before removing the fuel cap. Loosen the
cap slowly to relieve pressure in the tank.
Only fill or drain fuel outdoors in a well-ventilated area.
DO NOT pump gas directly into the engine at the
gas station. Use an approved container to transfer
the fuel to the engine.
DO NOT overfill the fuel tank.
Always keep fuel away from sparks, open flames,
pilot lights, heat and other sources of ignition.
DO NOT light or smoke cigarettes.
When starting the engine:
DO NOT attempt to start a damaged engine. Make
certain that the gas cap, air filter, spark plug,
fuel lines and exhaust system are properly in
place. Allow spilled fuel to evaporate fully before
attempting to start the engine.
Make certain that the chemical pump is resting
firmly on level ground.
When operating the chemical pump:
DO NOT move or tip the chemical pump during
operation.
DO NOT tip the chemical pump or allow fuel or oil
to spill from the engine. Block the wheels to prevent
unintended movement.
When transporting or servicing the chemical
pump:
Make certain that the fuel shutoff valve is in the off
position and the fuel tank is empty.
Disconnect the spark plug wire.
When storing the chemical pump:
Store away from sparks, open flames, pilot lights,
heat and other sources of ignition.
WARNING
Water pumped through this unit shall not be used
as drinking water.
WARNING
DO NOT remove either prime (top), or drain (bottom)
plugs while the chemical pump is on and running
Loss of pressure and suction will occur. Property
damage and injury may also occur.
WARNING
DO NOT pump salt, sludge, sewer, sea, or any other
type of water containing solid material.
WARNING
Rapid retraction of the starter cord will pull hand and
arm towards the engine faster than you can let go.
Unintentional startup can result in entanglement,
traumatic amputation or laceration.
Broken bones, fractures, bruises or sprains could result.
When starting engine, pull the starter cord slowly until
resistance is felt and then pull rapidly to avoid kickback.
CAUTION
Exceeding the chemical pump's specification for
maximum head can damage the chemical pump
and/or hose kits connected to it.
DO NOT modify the chemical pump in any way. DO
NOT attempt to exceed the rated flow. Attempting
to increase the rated flow may damage the unit
and/or shorten its life.
CAUTION
Improper treatment or use of the chemical pump can
damage it, shorten its life and void your warranty.
Use the chemical pump only for intended uses.
Operate only on level surfaces. DO NOT expose
chemical pump to excessive moisture, dust, or dirt.
DO NOT allow any material to block the cooling slots.
DO NOT use the chemical pump if:
– Equipment sparks, smokes or emits flames
– Equipment vibrates excessively
CAUTION
The pump is not meant to pull through, pass, or
pump any solids. Please make sure material that is
pumped is liquid only. Solids, debris and trash may
cause damage to the pump.
CAUTION
Lay sturdy planking along each side of the hose or
pipe, when the hose or pipe runs across any type
of roadway. Make sure that the planking length will
run the length of the roadway. This will ensure some
protection of the hose or pipe from any passing
vehicles.
SAFETY RULES
4

Advertisement

Table of Contents
loading

Table of Contents