Assembly; Remove The Semi-Trash Pump From The Shipping Carton; Install The Wheel Kit; Install The Vibration Mounts - Champion 66520 Operator's Manual

ASSEMBly

Your semi-trash pump requires some assembly. This unit
ships from our factory without oil. It must be properly
serviced with fuel and oil before operation.
If you have any questions regarding the assembly of your
semi-trash pump, call our help line at 1-877-338-0999.
Please have your serial number and model number
available.
Remove the Semi-trash Pump from the
Shipping Carton
Set the shipping carton on a solid, flat surface.
Remove everything from the carton except the
semi-trash pump.
Carefully cut each corner of the box from top to bottom.

Install the Wheel Kit

CAUTION
The wheel kit is not intended for over-the-road use.
You will need the following tools to install the wheels:
– 17 mm wrench OR adjustable wrench (not included)
– Socket wrench with a 16 mm socket (not included)
1. Slide the M10x105 wheel bolt through the washer,
sleeve and wheel.
2. Slide the bolt through the mount point on the frame.
3. Fasten securely with the M10 nut.
4. Repeat steps 1-3 to attach the second wheel.
7

Install the Vibration Mounts

1. Attach the support leg with rubber vibration mounts
to the frame cross member using a flange bolt
(M8x16) and nut (M8).
2. Thread the flange bolt through the vibration mount
and the frame.
3. Secure with nut. Tighten, but DO NOT over tighten.
4. Repeat steps 1-3 for second other side of the leg.

Install the Handle

1. Place the handle over the mounting channel on the
frame.
2. Secure the handle to the frame using the two handle
bolts (M8x45).
3. Place a lock nut (M8) on the end of each bolt and
fasten securely. DO NOT over tighten the lock nuts.
66520
ENGLISH