Table of Contents
Advertisement
Assembly
Your semi-trash pump requires some
assembly. This unit ships from our factory
without oil. It must be properly serviced
with fuel and oil before operation.
If you have any questions regarding the
assembly of your semi-trash pump, call our
help line at 1-877-338-0999. Please have
your serial number and model number
available.
Remove the Semi-trash pump
from the Shipping Carton
1.
Set the shipping carton on a solid, flat
surface.
2. Remove everything from the carton
except the semi-trash pump.
3. Carefully cut each corner of the box
from top to bottom. Fold each side flat
on the ground to provide a surface area
to install the wheel kit.
Install the Wheel Kit
CAUTION
The wheel kit is not intended for over-the-road
use.
You will need the following tools to install
the wheels: (not included)
12 mm wrench
Socket wrench with a 12 mm socket
Pliers
1.
Before adding oil to the engine, tip the
water pump slowly so that the engine
side is up.
2. Attach the axle to the bottom of the
frame with four mounting bolts and
nuts.
3. Slide a wheel onto the axle.
4. Place a washer on the end.
5. Install the cotter pin through the hole on
the end of the axle.
6. Carefully bend the legs of the cotter pin
back around the axle.
Rev C46530-20081202
7. Repeat steps 3-6 to attach the second
wheel.
Install the Support Leg
1.
Attach the rubber vibration mount to
the support leg with a cap screw
(M8x25) and lock nut (M8).
2. Attach the support leg to the water
pump frame with cap screws (M8x16)
and lock nuts (M8).
3. Tip the water pump slowly so that it
rests on the wheels and support leg.
Install the Handle
1.
Line up the holes at the base of the
handle with the receiving holes on the
semi-trash pump frame.
2. Thread cap screws (M8x50) through the
frame and handle.
3. Place a lock nut (M8) on the end of the
cap screw and fasten securely. DO NOT
over tighten the lock nut.
Add Engine Oil
CAUTION
DO NOT attempt to crank or start the engine
before it has been properly filled with the
recommended type and amount of oil. Damage
to the semi-trash pump as a result of failure to
follow these instructions will void your warranty.
1.
Place the semi-trash pump on a flat,
level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Add 0.63 qt (0.6 L) of oil and replace oil
fill cap/dipstick.
4. Check engine oil level daily and add as
needed.
CAUTION
The engine is equipped with a low-oil-shutoff and
the will stop when the oil level in the crankcase
falls below the threshold level.
Assembly
7
Advertisement
Table of Contents
