Status/Mode Indicators; S (Snap), Q (Quantize), And Settings Buttons - Native Instruments TRAKTOR KONTROL Z2 Manual

5.4.13

Status/Mode Indicators

The status/mode indicators and the S (Snap), Q (Quantize), and Settings buttons below.
The three icons at the very top of the center panel of the Z2 tell you important operating status
information. There are three different LED indicators: alert symbol, USB symbol, and the Time-
code symbol. The following table describes the messages:
INDICATOR
Alert symbol
USB symbol
Timecode symbol
5.4.14

S (Snap), Q (Quantize), and Settings Buttons

The S (Snap), Q (Quantize), and Settings buttons with the status/mode indicators above.
TRAKTOR KONTROL Z2 Hardware Reference
MEANING
Low RAM, flashes at a one-second interval
No connection to computer: Dim state
Controller action being triggered: Flashing
Connection established: Brightly lit
Failed Timecode calibration: Blink (one second inter-
val)
Low input level: Fast blink (0.5 second interval)
Ground hum detected: Fast blink (0.5 second inter-
val)
Left or right channel missing: Fast blink (0.5 second
interval)
TRAKTOR KONTROL Z2 - Manual - 55
Top Panel