Download Print this page

Fabtech FTS22107 Installation Instructions

2008-2015 ford super duty 4wd rear box kit for 10” rear lift

Advertisement

Quick Links

Tool List: (Not Included)
Floor Jack
Jack Stands
Assorted Metric and S.A.E Sockets & Allen Wrenches
READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION!
THE FACTORY READ LOAD CARRYING CAPACITY WILL BE REDUCED WITH USE OF THIS REAR SPRING KIT
2008-2015 FORD SUPER DUTY 4WD
BOX KIT FOR 10"
FTS22107
Qty
Part #
1
FT20073
1
FT30240BK
1
FT30241BK
1
FT30354
4
FT744U
2
FTBK2
1
FTS419
2
FTS42000
FT30354
Qty
Part #
4
37000005081
2
37160003052
2
37161001081
4
50000005081
2
50130003052
2
50131501081
2
FT22107i
1
FT58H
1
FTAS12
1
FTAS16
1
FTREGCARD
REAR LIFT
FTS22107
Rear Lift For 10" F-250
Description
Carrier Bearing Drop Bracket
Drv. Sway Bar Bracket
Pass. Sway Bar Bracket
Hdwr Sub-Assembly Kit
U-Bolt
2" Block
S/D Driveshaft Shim Kit
Rear Leaf Pack
Hdwr Sub-Assembly Kit
Description
3/8" SAE Flat Washer
3/8"-16 NyLok Nut
3/8"-16 x 1" Hex Bolt Gr. 8
1/2" SAE Flat Washer
1/2"-13 Nylok Nut
1/2"-13 x 1 1/2" Hex Bolt Gr. 8
Instruction Sheet
U-Bolt Hardware
Sticker
Driver Warning Decal
Registration Card
REAR

Advertisement

loading
Need help?

Need help?

Do you have a question about the FTS22107 and is the answer not in the manual?

Questions and answers

Summary of Contents for Fabtech FTS22107

  • Page 1 REAR 2008-2015 FORD SUPER DUTY 4WD BOX KIT FOR 10” REAR LIFT FTS22107 FTS22107 Rear Lift For 10" F-250 Part # Description FT20073 Carrier Bearing Drop Bracket FT30240BK Drv. Sway Bar Bracket FT30241BK Pass. Sway Bar Bracket FT30354 Hdwr Sub-Assembly Kit...
  • Page 2 INSTRUCTIONS: 6. Locate the factory brake line mount on the driver side of the 1. Disconnect the negative terminal on the battery. Jack up axle. Remove the vent line from the bolt and remove the bolt. the rear end of the vehicle and support the frame rails Save hardware.
  • Page 3 Frame section FT20073 8. Install Fabtech shock part number FTS7266 (not included) with the factory hardware and torque bolts to 65 ft-lbs. FTS419 9. Locate FT20073 Angle Carrier Drop Spacer, supplied 7/16” hardware, and FTS419. Remove the two bolts securing the drive shaft carrier bearing to the frame cross member.