Fabtech FTS22101 Installation Instructions

2008-2011 ford super duty 4wd rear lift for 6” f-250 with or without factory over load leaf

Download this manual

REAR LIFT FOR 6" F-250

Tool List: (Not Included)

Floor Jack

Jack Stands

Assorted Metric and S.A.E Sockets & Allen Wrenches

READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION!

IF TRUCK IS EQUIPPED WITH REAR SWAY BAR,FTS92010BK REAR SWAY BAR DROP

2008-2011 FORD SUPER DUTY 4WD

With or Without FACTORY OVER LOAD LEAF

FTS22101

PARTS LIST:

Qua

Part #

FTBK5

FT742U

FT58H

FTS419

FT30166

31182001081

31000005252

FT22101i

BRACKET CAN BE PURCHASED.

Description

5" Block

U-Bolt

5/8" Hardware

Shim Kit

E-Brake Cable Sleeve

5/16"-18 x 2" Bolt gr.8

5/16" Split Washer

Instruction Sheet

Page 1 2008-2011 FORD SUPER DUTY 4WD REAR LIFT FOR 6” F-250 With or Without FACTORY OVER LOAD LEAF FTS22101 PARTS LIST: Part # Description FTBK5 5" Block FT742U U-Bolt FT58H 5/8" Hardware FTS419 Shim Kit FT30166 E-Brake Cable Sleeve 31182001081 5/16"-18 x 2" Bolt gr.8 31000005252 5/16"...
Page 2 3. Locate and install the rear lift blocks, the factory block will WITHOUT THE FACTORY OVER LOAD be positioned on top of the new Fabtech block, with the SPRING SET-UP short center pin of both blocks facing down, to the axle.
Page 3 VEHICLE! 8. Locate and install the rear lift blocks, the factory block will be positioned on top of the new Fabtech block, with the short center pin of both blocks facing down, to the axle. The short end of the blocks should face to the front of the vehicle.
Page 4 axle using the factory hardware. Using the supplied 3/8” x 2” bolt, nut, and washer attach the brake line to the other Bend bracket downward to end. Reattach vent line. SEE PHOTO BELOW. give the cable more slack RESUME INSTALLATION ON ALL TRUCKS 14.