Advertisement
Quick Links
REAR LIFT FOR 8" F-250 W/OUT FACTORY OVER LOAD
Tool List: (Not Included)
Floor Jack
Jack Stands
Assorted Metric and S.A.E Sockets & Allen Wrenches
Drill w/ Assorted Drill bits
READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION!
2008-2015 FORD SUPER DUTY 4WD
LEAF FTS22104
FTS22104
Qty
Part #
2
FTBK5
4
FT742U
2
FT30275
1
FT30321
1
FTS419
1
FT30240BK
1
FT30241BK
FT30321
Qty
Part #
2
FT22104i
1
FT30166
1
FT90080
2
FT30284
1
FT30620
REAR LIFT KIT
08 F- 250 8" Rear Kit
Description
5" Block
U-Bolt
Add-A-Leaf
Hdwr Sub-Assembly
Shim Kit
Drv. Sway Bar Bracket
Pass. Sway Bar Bracket
Hdwr Sub-Assembly Kit
Description
Instruction Sheet
E-Brake Cable Sleeve
Center Pin Kit
Leaf Spring Spacer
Hardware Kit
Advertisement
Related Manuals for Fabtech FTS22104
Summary of Contents for Fabtech FTS22104
- Page 1 2008-2015 FORD SUPER DUTY 4WD REAR LIFT FOR 8” F-250 W/OUT FACTORY OVER LOAD LEAF FTS22104 REAR LIFT KIT FTS22104 08 F- 250 8" Rear Kit Part # Description FTBK5 5" Block FT742U U-Bolt FT30275 Add-A-Leaf FT30321 Hdwr Sub-Assembly FTS419...
- Page 2 INSTRUCTIONS: 1. Disconnect the negative terminal on the battery. Jack up the rear end of the vehicle and support the frame rails with jack stands. Supporting the rear differential remove and discard the rear shocks and u-bolts. Lower the axle down slowly.
- Page 3 BELOW 6. Locate and install the rear lift blocks, the factory block will be positioned on top of the new Fabtech block, with the short center pin of both blocks facing down, to the 7. Install Fabtech shock part number FTS7266 Performance axle.
- Page 4 10. Locate the FT30240BK (driver) and FT30241BK (pass) End link on Rear Sway Bar Drop Brackets. Remove the factory sway inside of bracket bay end links from the frame and the sway bar ,save the hardware. Place the drop bracket onto the frame so that the hole in the new bracket is directly above the factory hole (the longer end of the bracket goes upward and attaches to the frame).
- Page 5 13. 2011 models only .Locate the factory brake line mount 14. Recheck all bolts for proper torque. Recheck brake hoses and lines for proper clearances. on the driver side of the axle. Remove the vent line from the bolt and remove bolt, save hardware. Locate the supplied brake line bracket FT30059 in front box kit;...