Go Rhino DOMINATOR SERIES Assembly/Installation Instructions

02-08 dodge ram quad cab

Download this manual

REV/B

Do not attempt to install this product on any vehicle other than the one it is designed for and listed above!

QTY

PARTS DESCRIPTION

3/8" X 2" HEX BOLTS

3/8" HEX NUTS

3/8" LOCK WASHERS

3/8" FLAT WASHERS

Read the instructions completely before you begin the installation.

If your vehicle is equipped with factory running boards, remove the boards, brackets and fasteners.

This installation uses (3) mounting brackets per side, and requires drilling (2) holes in the lower body

pinch mold for each bracket.

It is the installer's responsibility to confirm all measurements and that there are no obstructions such as

brake, fuel or electrical lines before drilling.

Step 1. Beginning with the passenger side measure reward from the front fender bolt (refer to diagram for

dimensions) and scribe (6) vertical lines on the body pinch mold.

DOMINATOR SERIES SIDESTEPS

ASSEMBLY & INSTALLATION INSTRUCTIONS

PART NO. D24097 02-08 DODGE RAM QUAD CAB

INSTALLATION INSTRUCTIONS

QTY

PARTS DESCRIPTION

3/8" X 1" HEX BOLTS

D02 FRONT AND REAR MOUNTING BRACKETS

D03 CENTER MOUNTING BRACKETS

D24097P PASSENGER SIDESTEP

D24097D DRIVER

SIDESTEP

Need help?

Do you have a question about the DOMINATOR SERIES and is the answer not in the manual?

Page 1 REV/B DOMINATOR SERIES SIDESTEPS ASSEMBLY & INSTALLATION INSTRUCTIONS PART NO. D24097 02-08 DODGE RAM QUAD CAB Do not attempt to install this product on any vehicle other than the one it is designed for and listed above! PARTS DESCRIPTION PARTS DESCRIPTION 3/8”...
Page 2 D02 MOUNTING BRACKETS D03 MOUNTING BRACKET REAR OF VEHICLE D24097P PASSENGER SIDESTEP FRONT FENDER BOLT Step 2. Measure up from the bottom edge of the pinch mold 7/16” and scribe intersecting lines. Step 3. Confirm the measurements, center punch and drill 3/8” holes through the body pinch mold. Repeat the above steps for the driver side.
Page 3 Step 4. Loosely attach the mounting brackets to the body pinch mold using the 3/8” x 2” hex bolts, flat washers, lock washers and hex nuts as shown.
Page 4 Step 5. Position the passenger sidestep up to the mounting brackets and loosely attach it to the brackets using the 3/8” x 1” hex bolts, flat washers, lock washers and hex nuts. Step 6. Align sidestep with the body and then tighten all mounting bracket and sidestep nuts and bolts. Step 7.

D24097