Advertisement
Quick Links
PART NO. D24050 07-08 CHEVY/GMC CREW CAB PICKUP 2/4WD
Do not attempt to install this product on any vehicle other than the one it is designed for and listed above!
QTY
PARTS DESCRIPTION
4
5/16" U-NUTS
4
5/16" X1" HEX BOLTS
2
8MM X 25MM HEX BOLTS
6
5/16" LOCK WASHERS
6
5/16" FLAT WASHERS
18
3/8" x 1 " HEX BOLTS
18
3/8" LOCK WASHERS
STEP 1. Read the instructions completely before you begin the installation.
If the vehicle is equipped with factory running boards, remove the fasteners and
DOMINATOR 2 SERIES SIDESTEPS
ASSEMBLY & INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
QTY
PARTS DESCRIPTION
18
3/8" FLAT WASHERS
18
3/8" HEX NUTS
3
C07P PASSENGER MOUNTING BRACKETS
3
C07D DRIVER MOUNTING BRACKETS
1
D24050P PASSENGER SIDESTEP
1
D24050D DRIVER SIDESTEP
running
FRONT FENDER BOLT
boards.
Advertisement
Related Manuals for Go Rhino DOMINATOR 2 SERIES
Summary of Contents for Go Rhino DOMINATOR 2 SERIES
- Page 1 DOMINATOR 2 SERIES SIDESTEPS ASSEMBLY & INSTALLATION INSTRUCTIONS PART NO. D24050 07-08 CHEVY/GMC CREW CAB PICKUP 2/4WD Do not attempt to install this product on any vehicle other than the one it is designed for and listed above! PARTS DESCRIPTION PARTS DESCRIPTION 5/16”...
- Page 2 STEP 2. This installation uses three mounting brackets per side. Begin by installing the passenger side front mounting bracket. Measure reward from the front fender bolt approximately 14” and Locate the single hole in the body pinch mold and the square nut spot welded in the rocker panel. 8MM SQUARE NUT ROCKER PANEL PINCH MOLD...
- Page 3 PLASTIC PLUG PINCH MOLD STEP 4. Locate the holes in the body pinch mold and rocker panel for the center and rear mounting brackets. Measure rearward from the front fender bolt approximately 58 7/8” for the center and 75 1/8” for the rear bracket.
- Page 4 CENTER AND REAR BRACKETS PASSENGER SIDE FRONT BRACKET C07P MOUNTING BRACKET D24041P SIDESTEP 3/8” X 1” HEX BOLTS, FLAT WASHERS, LOCK WASHERS & HEX NUTS STEP 6. Position D24050P passenger sidestep up to the vehicle and loosely attach it to the mounting brackets using the 3/8”...