Connecting The Power Adapter - Olympia Protect Series Operating Manual

Connecting the Power Adapter

Power is supplied to the base unit of the alarm system via the power adapter. To ensure an uninterrupted power
supply, you can insert the optionally available batteries the base unit (see Section Inserting the Batteries (Option)
).
1
Loosen the screw in the battery compartment cover using an appropriate screwdriver.
2
Remove the battery compartment cover.
3
Plug the power adapter in the connection socket for the power adapter on
the underside of the base unit.
4
Replace the battery compartment cover and tighten the screw in
the battery compartment cover tight.
5
Plug the power adapter in a properly installed power socket.
If you want to insert a SIM card or batteries in the base
unit, refer to the sections "Inserting a SIM Card (Op-
tion)" and "Inserting the Batteries (Option)" before
closing the battery compartment.
Use the cable duct to lay the power cable on the
underside of the base unit.
PUTTING THE BASE UNIT INTO OPERATION
P
19
ROTECT