Wiring And Setting Up The Backup Battery; Connecting The Radio Frequency (Rf) Remote Control Unit - Besam Swingmaster MP Installation, Adjustment And Maintenance Instructions

Wiring 0p.t.io.n.s

Wiring and setting up the backup battery

Icupl
o
)1 connects to TB2 on the control unit. )2 is the terminal for the battery packs. )3 is not used.

Connecting the Radio Frequency (RF) remote control unit.

Place the receiver unit in the open space in the header.
Note I The single black wire at the bottom of the receiver-unit is the
antenna, and must not be confused with the power input black wire in
the group of five wires at the top of the receiver unit.
Connect the power input (red and top black wires) of the receiver unit,
red to terminal 19 on TB1 and black to terminal 20 on TBl. Connect the
switch output (orange and brown wires), orange to terminal 3 on TBI and
brown to terminal 4 on TB1.
'" Arrange the antenna wire just inside the cover. For improved range, drill
a small hole in the cover and run the antenna outside the case. Fasten the
wire with silicone sealant and seal the end cover hole as well.
Using two pushplates, with different timing for each (e.g., normal
and handicapped).
Wire a pushplate with a normally open switch to the key switch inputs (l and 4), then use the PMD
to program Function 09, "Key Operation", to a value other than 00 (e.g., 05
time). See page 39 for standard pushplate connection.
Swingmaster MP US23-0186-01
3-26-99
C Copyr9't 1999 Besam Automated
CUP
TB2
I
c»fuUr:.eo~
AnO,.""
5 seconds of hold open
=
Adjustments And Troobleshooting - 47
Ire.
Enlrance Syslems. May not be reprirted WIthout pet'mission
_
Jl EUS
12345
r~~
f'fff
I
I
l2J