Mounting/Removal - Siemens SITOP series Operating Instructions Manual

Mounting/removal

Installing the device in a housing or a control cabinet
The SITOP modular power supply is a built-in device. It must be installed in a housing or
control cabinet, to which only qualified personnel have access.
The device can be mounted in a control cabinet on standard mounting rails according to
EN 60715.
Mounting
To mount the device, position it with the mounting rail guide at the upper edge of the
standard mounting rail and press down to lock it into place. If this is too difficult, press slider
①
Removing
To remove, pull up the slider
bottom edge of the standard mounting rail. Then you can remove the device from the upper
edge of the standard mounting rail.
Figure 3-1
SITOP modular 1ph/2ph
Operating Instructions, 06.2014, C98130-A7548-A1-3-7629
WARNING
at the same time, as described under "Removal".
Removal (example, 6EP1334-3BA10)
①
using a screwdriver
②
and disengage the device at the
3
21