Mounting/Removal - Siemens SITOP SEL1200 8 x 5 A Equipment Manual

Mounting/removal

Installing the device in a housing or a control cabinet
The SITOP SEL1200-1400 selectivity modules are built-in units. They must be installed in a
housing or control cabinet where only qualified personnel have access.
The device can be mounted in a control cabinet on standard mounting rails (see Chapter
Mechanical system (Page 55))
Mounting
To mount the device, position it with the mounting rail guide at the upper edge of the
standard mounting rail and press down to lock it into place. If this is too difficult,
simultaneously press the slider
Removal
To remove, pull up the slider
(Page 29)) and disengage the device at the bottom edge of the standard mounting rail. Then
you can remove the device from the upper edge of the standard mounting rail.
Figure 3-1
SITOP SEL1200-1400
Equipment Manual, 06.2020, A5E46496083-2-76
WARNING
Mounting-removal
⑨
as described under "Removal".
⑨
using a screwdriver (see Figure 3-1 Mounting-removal
3
29