Playback; Playback Mode; Chase Playback; Speed - Chauvet DJ Foot-C 2 User Manual

5. P
LAYBACK

Playback

Mode
Chase
Playback

Speed

Fade

Foot-C User 2 Manual Rev. 2
Playback is used to play back saved scenes and chases. It is the mode to use when the
show is happening. In playback mode, the saved scenes and chases are triggered to play
back. There are four playback types:
Scene Playback - Playing back saved scenes.
•
• Chase Playback - Playing back saved chases.
MIDI Playback - Using a MIDI input signal to play back scenes and chases.
•
• Live Playback - Controlling the outputs without the use of scenes or chases.
Not recommended.
To operate any of the modes that offer amber, white, or UV color options, the
selected fixture must be capable of outputting that corresponding color light.
Chase playback triggers a specific chase (1–12) for playback with auto, audio, MIDI, or
Tap Sync triggering. The middle display shows the selected chase, the current step, and
the total number of steps in that chase.
To enter Chase Playback mode, press <MODE>. Chase 1 will automatically be selected.
Use <UP> and <DOWN> to select a chase. Press <ENTER (TAPSYNC)>.
There is no way to manually trigger the steps in a chase in playback mode.
The speed setting determines how long each step in a chase will be active in Auto mode,
before the next step is triggered.
To set speed, do the following:
1. Play back a chase.
2. Press and hold <BLACKOUT / FUNCTION> until SPEEd 0–16 shows on the middle
display.
3. Use <UP> and <DOWN> to select the desired speed. 0 will halt auto triggering. 1–16
is in order from slowest to fastest speeds.
4. Press<ENTER (TAPSYNC)> until the display shows the current scene or chase to
exit speed setting.
The fade setting determines how long it takes one scene or step to change, or fade, to the
next scene or step.
To set fade, follow the instructions below:
1. Play back a scene or chase.
2. Press and hold <BLACKOUT / FUNCTION> until SPEEd XX (XX designates a
numerical value from 00 to 16) shows on the middle display.
3. Press <ENTER (TAPSYNC)> once. The middle display will show FAdE XX.
Use <UP> and <DOWN> to select the desired fade. 00 will set the scenes or steps to
4.
snap immediately to the next when triggered. 01–16 is in order from fastest to
slowest fade rate curves.
5. To exit the fade rate setting, press <ENTER (TAPSYNC)> once. The display should
show the current scene or chase.
Page 21 of 90