Imperx Cheetah C2020 User Manual page 28

Cheetah Pregius Camera with Camera Link – User Manual
Load From . . .
This enables loading camera registers from a saved configuration space. Options are:
•
File: Loads camera registers from a saved configuration file.
•
Workspace: Updates the software with the current camera workspace settings.
•
Factory: Loads the camera registers with the original factory settings.
•
User Space #1 to #4: Loads the camera registers with settings saved within the
camera from any of the camera user spaces: #1 to 4
Save To . . .
You can save the camera registers to a file or the camera User Spaces. Factory Space is
available only for factory technicians.
Boot From . . .
This enables loading the camera registers from the Factory configuration, from User Space
#1, #2, #3, or #4 upon powering up.
Command Terminal
The Command Terminal shows information about all commands sent to or received by the
camera. It also lets you communicate directly with the camera by entering write or read
commands directly into the text box on the Command Terminal screen.
To write a command to a camera register, the command terminal must send a sequence
of 7 bytes to the camera. The write command must start with 0x followed by 57, the
register address, and data.
Example:
Write to register address 0x0410, data value = 0x11223344:
Camera Write Command: <0x57> <04> <10> <11> <22> <33> <44>
To read a command from a camera register, the command terminal must send a sequence
of 3 bytes to the camera. The read command must start with Ox followed by 52 and the
register address.
Example:
Read from register address 0x0410:
Camera Read Command: <0x52> <04> <10>
Figure 18: Command Terminal command to addresses 055C and register 0560.
July 6, 2018 Page
28 of 64
Rev 1.1