Eaton 600 A 35 kV class Installation Instructions page 3

600 A 35 kV class insulated protective cap
PULLING EYE
Stainless Steel Pulling Eye
Ensures high strength for
hotstick operation.
DRAIN WIRE AND EYE
30-inch, #14 AWG Stranded Tin
Plated Copper drain wire
prevents low energy discharge
from the molded semi conducting
shield.
Figure 2. U-OP™/T-OP™ II connector cap cutaway shows design characteristics and dimensions.
N otee: Dimensions given are for reference only.
Ordering information
To order a 35 kV Class Protective Cap Kit, refer to Table 2.
Table 2. Protective Cap Kits
Description
600 A 35 kV Protective Caps
Standard Protective Cap with Drain Wire w/Permanent Stud
(See Figure 1) (Individually Bagged)
Standard Protective Cap with Drain Wire w/Permanent Stud
(Individually Boxed)
Protective Cap for T-OP II and U-OP Connector Applications w/
out Stud (See Figure 2) (Individually Bagged)
Protective Cap for T-OP II and U-OP Connector Applications w/
out Stud (Individually Boxed)
Each kit contains
Protective Cap
•
Silicone Lubricant
•
Installation Instruction Sheet
•
5
/ "-11 UNC 2A Threaded Aluminum
8
Insert allows cap to be installed on
bushing using either a standard 600 A
stud, the extended stud used with
T-OP™ II or the U-OP™ stud.
8.66"
(220 mm)
Catalog Number
DPC635
DPC635X
DPC635UT
DPC635UTX
Catalog Data CA650058EN
Effective May 2015
SEMICONDUCTIVE SHIELD
Molded Semiconductive EPDM
Shield meets requirements of
IEEE Std 592™-2007 standard.
EPDM INSULATION
High Quality Peroxide Cured
EPDM Insulation is mixed and
formulated in-house for
complete control of raw rubber
characteristics.
www.eaton.com/cooperpowerseries
3.25"
(83 mm)
3