Benchmark Scientific Accuris SmartReader 96 User Manual page 4

The operator should not open or repair the Instrument by himself. This may void
the warranty and cause damage to the instrument. If service is required, please
contact Benchmark Scientific or your local distributor to arrange repair.
Before powering on, confirm that the electrical supply available matches the voltage
required for the instrument as specified on the serial number plate. Also confirm that
the rated load of the electrical outlet is not lower than required.
If the electric line is damaged, replace it with the same type.
The Instrument should be installed in an area put in an area with minimal dust, away
from wet areas, and away from direct sunlight. In additional the installation location
should have sufficient ventilation, but away from electromagnetic interference and
heat sources. The vent on the Instrument is designed for proper cooling of the
internal components. Do not cover the vent, or place the instrument in a location
where the vent can be blocked.
Power off the instrument when not in use. If the instrument will not be used for a
long period of time, cover it with a cloth or plastic to protect it from dust.
Disconnect the power cord from the jack at once in the following cases, and contact
Benchmark or your local distributor:
⚫
Liquid enters the Instrument;
⚫
Abnormal operation: such as abnormal sound or smell.
⚫
Instrument dropped or outer housing damaged.
⚫
The function has obviously changed.
3 Maintenance of the Instrument
The microplate holder should be cleaned using a cloth damp with a small amount of alcohol.
Other parts and the outer housing of the instrument can be cleaned as needed with a cloth damp
with water or a mild detergent.