Protocol Setting; Measure Settings - Benchmark Scientific Accuris SmartReader 96 User Manual

MR-9600 Microplate Reader User Manual
Note: During a reading, a dialog box will indicate "measuring now", and all buttons are
disabled, except for "Stop" which can be used to interrupt the measurement.
④ Measurement will take approximately 15 seconds, and upon completion the display will switch
to the "Report" interface to display measurement results (see Fig 11).
Results will depend on the parameters set. See section 3 on "Report Interface" for additional
information.

2. Protocol setting

After clicking
protocol by setting the parameters (wavelength, shaking settings, layout, data calculations, etc) and the
protocol can be saved.

2.1 Measure settings

Filter (Wavelength) and mode (reading speed) can be set in the Measure settings.
① On interface "Protocol", click on "Measure" to set the parameters. See Fig 12.
Fig 11
or choosing one of the demo protocols, one can create a new protocol
13
Chapter 5 Operation guide