Body Flex Sports Body Rider 35 Owner's Manual page 13

S T E P 6
Remove the four Screws (#55) that are pre-assembled on the back
of the Monitor (#1) and set them aside as they will be used later in
this step.
A. Connect Monitor Wire (#1a) to the Main Sensor Wire (Middle)
(#2) as illustration below.
B. Secure the Monitor (#1) to the bracket of the Center Post (#7)
using four Screws (#55).
C. Insert Hand Pulse Sensor Wire (Upper) (#4) to the hole on the
back of the Monitor (#1) as illustration below.
D. Correctly insert and install 2 AAA batteries to power Monitor (#1).
Attach the Center Handle Bar (#39) to the Center Post (#7) secure
them together by using two Bolts (#40), two Spring Washers (#10)
and two Arc Washers (#20).
The assembly process is now complete. However, for your own
safety, please make sure to read this entire Owner's Manual which
includes safety instructions and warnings, as well as any
safety/warning labels affixed to the product before use.
For your safety, please visually and functionally inspect and test
the unit after assembly is complete.
55
4
7
HBR35
assembly instructions
1
1a
13
2
39
10
20 40
P A R T S
#40
#55
x2
x4
A
B
55
C
4
#20
#10
x2
x2
1a
2
1
1
Page 11