Body Flex Sports Body Rider 35 Owner's Manual page 12

assembly instructions
S T E P 5
With the help of an assistant, attach the Left Handle Bar (#16L) to
the Center Post (#7). Insert two Bolts (#40) through two Spring
Washers (#10), two Arc Washers (#20) then Left Handle Bar
(#16L) and Center Post (#7). Screw the Bolt (#40) securely into the
Center Post (#7).
WIRE CONNECTION:
A. Remove Wire Plug (#8) from the Center Post (#7) being careful
not to pull on the wires (you do not need to remove the wires).
B. Carefully connect the heads of Hand Pulse Sensor Wire (Upper)
(#4) to the heads of Hand Pulse Sensor Wire (Lower) (#18).
C. 1. Remove the Wire Plug (#8) from its current position on the
Hand Pulse Sensor Wire (Upper) (#4) and then,
2. Transfer the Wire Plug (#8) back onto the Hand Pulse Sensor
Wire (Upper) (#4) on the new location -- the outer side of the
connected heads (this will allow you to tuck in the connected
heads and wires in next step).
D. Tuck the connected heads and wires into the hole on the Center
Post (#7) and carefully insert the Wire Plug (#8) back into the
Center Post (#7).
Repeat this process on the other side using Right Handle Bar
(#16R).
t e n s i o n a d j u s t m e n t
To increase the tension (+ higher level of intensity), turn the
Tension Controller (#6) in a clockwise direction.
To decrease the tension (- lower level of intensity), turn the
Tension Controller (#6) in a counter-clockwise direction.
"1" is the lowest level of tension (easiest level for workout);
"8" is the highest level of tension (most difficult level for
workout).
18
40
Page 10
18
4
4
16L
7
20
10
P A R T S
C
16R
40
10
20
D
#40
#10
x4 x4
A
18 4
18
8
8
7
4
1
7
8
16L
LEFT
SIDE
Remove #8 to transfer Tuck in wire, then insert in #8
1
7
8
16R
RIGHT
SIDE
Remove #8 to transfer
8
7
#20
x4
B
18
4
2
7
16L
8
2
7
16R
8
Tuck in wire, then insert in #8
HBR35