Body Flex Sports Body Rider 35 Owner's Manual page 11

S T E P 4
Connect the Main Sensor Wire (middle) (#2) to the Main
Sensor Wire (Lower) (#21) and then follow the instructions
in the diagram below to connect the Tension Controller
Wire (#22). After connecting the Tension Controller Wire
(#22) to the Tension Controller (#6) slide the Center Post
(#7) onto the Main Frame (#23) and secure them together
using the four Bolts (#9), four Spring Washers (#10) and
four Arc Washers (#11).
7
11
11
10
9
21
23
HBR35
assembly instructions
2
Make sure this wire is
exposed and accessible
before assembling the
Center Post (#7).
9
10
6
2
22
P A R T S
t e n s i o n w i r e a s s e m b l y
Insert the tip of the Tension Controller (#6)
wire into the Tension Controller Wire (#22)
head at an angle.
Tilt the Tension Controller (#6) wire into
the crevice and then pull upward.
2
21
#10
#9
x4
x4
A B
6
22
C D
#11
x4
Page 9