Page 3
STEP 1B - Transmitter Components TABLE 1. EMS2000SE-T COMPONENTS NUMBER IN DIAGRAM AT LEFT DESCRIPTION DESCRIPTION Power LED button Deactivated, not used 5 VDC Power In connector Connect to supplied power adapter Connect to PC/workstation USB USB Type B connector connector Speed LED Indicates 10/100/1000 Mbps...
Page 5
STEP 2B - Receiver Components TABLE 2. EMS2000SE-R COMPONENTS NUMBER IN DIAGRAM AT LEFT DESCRIPTION DESCRIPTION On/Off button Deactivated, not used 2, 3 (2) USB Type A connectors Connect to USB peripherals Microphone Connect to microphone Speakers Connect to speakers 5 VDC Power In connector Connect to supplied power adapter (2) USB Type A connectors...
STEP 4 - Connect the Peripherals CONNECT THE RECEIVER CONNECT THE TRANSMITTER 1. Attach the monitor, keyboard, mouse, USB 1. Attach the Emerald SE Transmitter to the and audio devices to the Emerald SE Receiver. target PC/workstation using DVI and USB Type B cables.
STEP 5 - Starting Up and Default Settings DEFAULT SETTINGS STARTING UP Default Settings: 1. Once everything is connected, press the Power button on the front of the Emerald SE Transmitter IP Address: 192.168.1.22 Receiver. Receiver IP Address: 192.168.1.21 2. The Graphical User Interface (GUI) will Type: Static appear on the screen.
Emerald SE monitor, and mouse to the remote unit (remote Transmitter or the Emerald SE receiver is unit is on at this time). required. This enables you to install the system quickly, directly out of the box.
5. Once the transmitter is configured, you can MATRIX INSTALLATION now configure the receiver. In a matrix installation, every Emerald SE 6. If the units are on different subnets, transmitter and receiver requires its own IP then routers will need to be used to properly address.
Page 10
STEP X - Name of Step Contact our free, 24/7 technical support in the US at 877-877-2269 or INFO@BLACKBOX.COM For other countries, go to BLACKBOX.COM/CONTACT-US COPYRIGHT 2018. BLACK BOX CORPORATION. ALL RIGHTS RESERVED. EMS2000SE_QSG_REV1.PDF...