Install Motor - PDMOVIE REMOTE AIR 4 User Manual

Instruction Manual

1.Install Motor

Install the motor on 19mm or 15mm (using the adapter) rods. At the same time, the motor gear stuck on the lens
gear. Then install the antenna to the main motor PD-RX.
1.Install the motor
on (15/19mm) rods.
2.Connection
PD2-M1(Single Channel): Connect the PD-RX (Receiver Motor) to a power source with the D-Tap Power Cable.
PD3-M2(Double Channel) ： PD-RX (Receiver Motor) and PD-MX (Slave Motor) can be connected by slave motor
cable, as long as the PD-MX (Slave Motor) is connected to the D-Tap Power Cable. Then, connect the D-Tap Power
Cable to the V-mount Power Cable.
PD2-M3 （ Three Channel) ： PD-RX (Receiver Motor) and PD-MX1 (Slave Motor 1) and PD-MX2 (Slave Motor 2) can
be connected in a daisy chain with two slave cables. PD-MX2 (Slave Motor 2) connects to the D-Tap power cable,
and the D-tap power cable connects to a V-mount power supply. The 7-20V interface on the motor is used for power
supply and signal transmission, it can be connected to your rig in whatever position is convenient for you.
PD-RX
(Reciever Motor）
WWW.PDMOVIE.CO.UK
Install
2.Locking U-clamp
The Slave Motor Cable
PD-MX
（Slave Motor）
PD-MX/MP
（Slave Motor）
REMOTE AIR 4 User Manual
3.Install the Antenna
and the Power Cable.
.
D-Tap Power Cable
5