PDMOVIE REMOTE AIR 4 User Manual page 7

Instruction Manual
3.Powering on (Turn on the controller and the motor)
Press and hold the ON/OFF button on the right side of the controller for three seconds, until the screen illuminates,
and then release the button. The motor does not need to be turned on or off, it will power on automatically when
connected to a power supply. Conversely, it will automatically turn off when disconnected.
4.Set up the signal channel, connect the controller to motor.
Check the readouts on the controller and master motors OLED monitors to see if they are on the same signal
channel. If the channels don t match, you can adjust the controller or the signal channel of the motor until they do.
Check for the signal icon on the top right corner of the screen to confirm a stable connection.
1.Check the consistency
of the channel number
Adjusting channel on the Motor and Controller: Press the Channel button once to cycle through the available
options until the channel number begins to blink. Then click the Channel button to change the channel. The
channel number will stop blinking and automatically return to normal after 5 seconds of non-operation. (Use the
same process to change the controller and the motor's channel)
5.Set up the controller channel
1.The controller has three inputs; hand-wheel and two rocker levers which can control three channels. The
hand-wheel controls the FOCUS (Red light), the left side rocker lever controls the ZOOM (Green light) and the right
side rocker lever controls the IRIS (Blue light). Both rocker levers on the sides can be set to green or blue according
to your requirements. The control channel can be changed by double clicking the button on either sides. (For
specific reference: see the schematic and channel list)
2.Check the color of the indicator light on the front of the motor, and confirm whether the motor is in the
corresponding control channel. Quickly double click the channel button of the motor to switch the control channel.
Motor setup channels are non-sequential.
Button input frequency
WWW.PDMOVIE.CO.UK
Set Up
2.Check signal intensity
Channel
R1
G2
B3
Y4
C5
P6
Indicator light colour
Red
Green
Blue
Yellow
Cyan
Purple
REMOTE AIR 4 User Manual
Control
Focus
Zoom
Iris
Channel 4(standby)
Channel 5(standby)
Channel 6(standby)
6