Installation - Philips Lytemode 6-Button Remote Station User Manual

Installation

The Lytemode ILS Network consists of a single CAT5e cable
connecting all ILS modules in a daisy chain manner. All units
connect to the network using a 9-pin connector (included).
To install:
Step 1. Unpack unit and inspect for any signs of shipping damage.
Ensure that two mounting screws are included.
Step 2. Connect ILS Network Cable to 9-pin connector at back of
6-Button Remote Station.
9-Pin
Connector
Rough-In Box
(not included)
Step 3. Insert 6-Button Station into standard deep rough-in box
(not included). Secure with two supplied mounting screws.
Step 4. Snap faceplate into place.
6
Installation
6-Button
Remote Station
Faceplate
9-Pin Connector Wiring
PIN SIGNAL
1 WH/OR (+ Data)
2 OR (- Data)
3 SHIELD
4 WH/GN (+ Volts)
5 GN (Ground)
6 WH/BL (+ Volts)
7 BL (Ground)
8 WH/BR (+ Volts)
9 BR (Ground)