TECNOEKA EKF423DUD Use And Instruction Manual page 11

Electric Ovens rev. 15_____________________________________________________________________DIGITAL LINE
To zero the DELAY TIME, just press the
than can be changed. Press the
start for the cooking cycle can be reset by proceeding as above.
N.B.: in case of BLACKOUT or power failure during the COUNTDOWN, the programmed delay
for the cooking cycle is cancelled and all the relative set parameters are zeroed.
A delayed start to the cooking cycle is only possible in MANUAL MODE. It cannot be included in
a programmed cooking cycle.
14. "Programmed" mode
Up to 99 cooking programs (cycles) can be saved. Each program can include 1 or more cooking
steps (up to 4).
15. Saving cooking programs
Follow the steps below to save a cooking program:
- press the button
- Press buttons
- Set the relevant cooking cycle parameters following the same procedure used for "manual"
mode.
- Press and hold down the
saved with the saved program number blinks on the display.
To cancel a saved program, simply replace it with a new program (with the same number) where
new parameters are set for the new cooking cycle. The new program must be saved by pressing the
button.
16. Cooking with a saved program
Follow the steps below to run a saved cooking program:
- press the button
- Press buttons
- Press the button
Note: To start the cooking cycle without preheating, press and hold the button
"P – H" appears on the display (cooking chamber "preheating" function).
The oven operates until it reaches a temperature equal to the value set for step 1 (programmed
cycle) increased by 30°C. When the preheating temperature is reached, "P – H" blinks on the
display and the buzzer sounds. At this point, open the oven door, introduce food to be cooked and
close the door. the buzzer turns off and the programmed cooking cycle starts.
N.B.: When the oven is operating in "programmed" mode, set parameters can be displayed in the
same way as with "manual" mode. For the user's convenience, set parameters can be changed
during oven operations in "programmed" mode.
At the end of the programmed cooking cycle, changed parameters are automatically "RESET" and
return to the values initially saved in the program.
17. Manual humidifying
Humidity can be produced in the cooking chamber (water solenoid valve on or activation of water
pump) at any time in the cooking cycle (in both "manual" and "programmed" mode) by pressing
the button (led on). Continuous humidity as long as the button is pressed.
________________________________________________________________________________________ page. 11
key; the display will show the operating parameters
again to continue the cooking cycle; otherwise a delayed
(led on) "P01" appears on the display.
and select the required program number (up to P99).
button for at least 5 seconds: the program is successfully
"P01" appears on the display.
and select the required program number
to start the cooking cycle with preheat..
for about 5 seconds.