802.11G Wireless - SATO S8412 Operator's Manual

802.11G WIRELESS

The wireless print server provides easy printer interface with 802.11g Wi-Fi compliant networks free of wired
connections. Each printer is shipped with an integrated driver and interface installed. The driver must be loaded
onto the host computer and configured to run one of the supported protocols.
Variable Data Rates
Frequency Band
Wired Equivalent Privacy
Sensitivity
Range
Protocols
Protocol
IP Address
Subnet Mask
Gateway Address
Communication Mode
SSID
Channels
The dipswitches serve to initialize the configuration saved on the Wireless-LAN board, print the configuration, and make a self-
diagnosis. To communicate with the host,set the communication mode by through switches 5 and 6, then set the remaining
switches to the OFF position.
Print of configuration and self-diagnsis are operable only on the screen after turning on the printer. Ensure all switches are in
the OFF position when operating the printer.
SWITCH
1 OFF
OFF
2
ON
OFF
3
ON
OFF
4
ON
NOTE: The communication mode may be set within the printer's Interface Mode. Go to [Communication] of the Interface Mode
to enable setup by either the dipswitches or through the Interface Mode.
Network Port
S8400 Series Operator Manual
Unit 3: Installation
SPECIFICATIONS
54, 11, 5.5, 2 and 1 Mbps
2.4 GHz ISM Band
128 bit, 64 bit (compatible with 40bit), none (WPA)
(typ, AAWGN, 8E-2 PER): -91dBm at 1Mbps, -88dBm at 2 Mdps, -87dBm at 5.5Mbps, -
84dBm at 11Mbps.
100m indoors, 300m outdoors (enviromentally dependent)
TCP/IP, IPX/SPX, Direct Mode IPX/IP, DLC/LLC, NetBEUI, NetBIOS/IP
Status3 return
Protocol for Driver (cyclic response mode)
Protocol for Driver (ENQ response mode)
Status5 return
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
802.11 Ad hoc, Ad hoc, Infrastructure
Optional alphanumeric character string (up to 32 characters)
01 to 11
DIPSWITCH SETTINGS
Normal operating setting.
Normal operating setting.
Initialization/Reset to factory default upon power up.
Normal operating setting.
Configuration report upon power up - prints diagnostic report upon powering up.
Wireless Mode setting.
WIRELESS LAN SIGNAL STRENGTH
Link LED
SETTING
Off 0 to 50% (weak)
Blinking 50 to 75% (medium)
On 75 to 100% (strong)
3-15
PN: 9001160B