Using The Operation Lock - Mitsubishi Electric PZ-60DR-E Operating Instructions Manual

Using the operation lock

Locking the remote controller buttons (Operation Lock)
If you wish, you can lock the remote controller buttons. You can use the Function
Selection of remote controller to select which type of lock to use. (For information
about selecting the lock type, see section "Installation Manual" [5. Function
Selection [2] (1)]
Specifically, you can use either of the following two lock types.
1 Lock All buttons:
Locks all of the buttons on the remote controller.
2 Lock All Except [
ON/OFF] button:
Locks all buttons other than the [
button.
Note:
The "Locked" indicator appears on the screen to indicate that buttons are currently
locked.
"Locked" will be displayed when operation is locked via Function Selection.
In addition, "Locked" will be displayed during Night purge, external fan speed
adjustment input (automatic fan speed), fan speed and function selector adjustment
input, Function Selection mode when using two remote controllers, and also in
maintenance mode.
<How to Lock the buttons>
1. While holding down the FILTER button 4, press and hold down the [
button 1 for 2 seconds. The "Locked" indication appears on the screen (at 1),
indicating that the lock is now engaged.
* If locking has been disabled in Function Selection of remote controller, the
screen will display the "NOT AVAILABLE" message when you press the buttons
as described above.
2
ON/OFF]
• If you press a locked button, the "Locked" indication (at 1) will blink on the
display.
<How to Unlock the buttons>
1. While holding down the FILTER button 4, press and hold down the [
button 1 for 2 seconds—so that the "Locked" indication disappears from the
screen (at 1).
1
"Locked"
Indicator
– 15 –
ON/OFF]
1
1
ON/OFF]
1