Using The Simple Timer - Mitsubishi Electric PZ-60DR-E Operating Instructions Manual

2 Using the Simple Timer

You can set the simple timer in any of three ways.
• Start time only: The Lossnay unit starts when the set time has elapsed.
• Stop time only: The Lossnay unit stops when the set time has elapsed.
• Start & stop times: The Lossnay unit starts and stops at the respective elapsed
times.
The simple timer (start and stop) can be set only once within a 72 hours period.
The time setting is made in hour increments.
When a 24-hour Ventilation setting is specified (Extra low operation set by
pressing the [ ON/OFF] button while running), when the timer expires the
system will go to Extra low operation instead of stopping.
Note:
*1. Weekly Timer/Simple Timer cannot be used at the same time.
*2. The simple timer will not operate when any of the following conditions is in effect.
The timer is off; the user is in the process of selecting a function; the user is in
the process of setting the timer; the system is under central control. (Under these
conditions, On/Off operation is prohibited.)
*3. When using a simple timer, the time will not be displayed on the screen, even if
the clock use setting is ON (use clock).
2 4 3
<How to Set the Simple Timer>
2
1. Be sure that you are at a standard control screen, and that the simple timer
indicator is visible in the display (at 1).
When something other than the Simple Timer is displayed, set it to SIMPLE
TIMER using the function selection of remote controller, refer to section
"Installation Manual" [5. Function selection [3] Mode selection (2) Timer function
setting].
MENU] button b, so that the "TIMER SET" appears on the screen
2. Press the [
(at 2). (Note that each press of the button toggles the display between "TIMER
SET" and "TIMER MONITOR".)
ON/OFF] button 1 to display the current ON or OFF simple timer
3. Press the [
setting. Press the button once to display the time remaining to ON, and then
again to display the time remaining to OFF. (The ON/OFF indication appears at
3).
• "ON" timer: The Lossnay unit will start operation when the specified number of
hours has elapsed.
• "OFF" timer: The Lossnay unit will stop operation when the specified number of
hours has elapsed.
4. With "ON" or "OFF" showing at 3: Press the appropriate [
as necessary to set the hours to ON (if "ON" is displayed) or the hours to OFF (if
"OFF" is displayed) at 4.
• Available Range: 1 to 72 hours
• Pressing and holding the button will fast-forward the display.
5. To set both the ON and OFF times, repeat Steps 3 and 4.
1
* Note that ON and OFF times cannot be set to the same value.
6. To clear the current ON or OFF setting: Display the ON or OFF setting (see step
3) and then press the CLEAR button 0 so that the time setting clears to "—" at
4. (If you want to use only an ON setting or only an OFF setting, be sure that the
setting you do not wish to use is shown as "—".)
7. After completing steps 3 to 6 above, press the
* "TIMER SET" indicator flashes three times.
Note:
Your new settings will be cancelled if you press the BACK button 2 before pressing
button 4.
the
8. Press the BACK button 2 to return to the standard control screen.
ON/OFF] button 9 to start the timer countdown. When the timer is
9. Press the [
running, the timer value is visible on the display. Be sure that the timer value is
visible and appropriate.
– 12 –
4
Timer Setting
3
Action (ON or OFF)
1
CLOCK] button a
button 4 to lock in the value.