Mitsubishi Electric PZ-60DR-E Operating Instructions Manual page 8

Function selector button
Operation Relevant button
1. Starting the Lossnay unit
Operation lamp
2. Setting the ventilation mode
3. Selecting the fan speed
4. Selecting the Extra Low fan
speed* 1 * 2
5. Stopping the Lossnay unit
Operation lamp
1
* If you press a button for a feature that is not installed at the Lossnay unit, the remote controller will display the "NOT AVAILABLE" message.
* 2 If set to "24-hour Ventilation", pressing the [
Extra low fan speed mode. To stop operation, press the [
Dot display
Relevant display items
Press the [
"High"
Press the Function selector button: Each time it is pressed, the corresponding display will
change in accordance with the sequence [HEAT EX.] (non-automatic) --> [BY-PASS] (non-
automatic) --> [AUTO].
"HEAT EX." non-automatic
Press the Fan Speed Adjustment button to select either Low or High (Extra High) fan
speed. High and Extra-High can be selectable by initial setting.
"Low" "Extra High"
Press the "Extra Low" fan speed button.
Extra low operation will begin. Pressing the Fan Speed Adjustment button will cause the
fan speed to revert to its original speed (before the Extra low mode began).
"Extra Low"
Pressing the Extra Low fan speed button again will return operation to Extra low mode.
Press the [
(Press the [
ON/OFF] button will cause this to be displayed in the dot display "24HR VENTILATION", and the operation will switch to
ON/OFF] button twice within 3 seconds, or press and hold the [
– 8 –
ON/OFF button
Fan Speed Adjustment button
"Extra Low" fan speed button
Sequence
ON/OFF] button and confirm that the Operation lamp turns on.
2
ON/OFF] button.*
ON/OFF] button to turn off the Operation lamp.)
ON/OFF] button for 5 seconds.