Rear Panel - Everlast PowerARC 210ST Operator's Manual

Section 2 General Setup and Operation
PowerARC 210STL
Rear Panel View
CONSULT A LICENSED ELECTRICIAN AND LOCAL CODES BEFORE WIRING YOUR FACILITY FOR YOUR UNIT!
EVERLAST IS NOT RESPONSIBLE FOR DAMAGE OR INJURIES RESULTING FROM IMPROPER WIRING.
MAIN POWER SWITCH
GAS CONNECTION
1x1110/220V
Even though the unit is grounded by the main
ground wire to the chassis, an additional bonded
ground may be necessary in some locations to
comply with code. Consult a locally licensed
electrician concerning the any requirement of this
connection and its proper use and application in
your region. This connection may be used to help
reduce and drain HF interference during arc starts.
NEMA 6-50P PLUG
Fe, Cu
240V TO 120V PLUG ADAPTER
IMPORTANT: USE THE 240V TO 120V ADAPTER TO SAFELY ADAPT THE NEMA 6-50P (INDUSTRY STANDARD 240V WELDER PLUG) TO THE
STANDARD NEMA 5-15P WHEN OPERATING ON 120V. THIS PLUG ADAPTER PRESERVES THE POLARITY REQUIREMENT FOR OPERATION ON 120V.
16